S4 Bench Thickness Gauge
- Constant anvil pressure
- Digital-resolution to 0.01 mm
- Ranges of different anvils & weights
- Optional RS232C Interface
This digital gauge accurately measures the thickness of rubber and similar soft materials using a constant pressure anvil. The gauge conforms to international test standards and is widely used when testing rubber for tensile strength and compression set. The 150mm-diameter base provides a smooth flat ground surface upon which the test piece is placed. Location for a lower anvil, required by some standards, is also provided. The digital indicator is attached to an arm, which can slide on a vertical column.
Throughout the dial gauge travel (25mm), a constant force on the spindle ensures the anvil pressure on the test piece in constant.
A lifting lever attached to the indicator raises the spindle and upper anvil, allowing easy location of the test piece.
Various diameter anvils can be screwed into the dial gauge spindle.
A range of additive weights can be placed in the carrier at the upper end of the spindle, which creates the correct anvil pressure on the test piece.
A software package is available which exports data from the indicator to a PC for further analysis.