• Analyze cure curve and cure property
• Improved closed die cavity structure
• Quick temperature heat-up and stabilization
Automation
The new EKT-2003SA is delivered with an automatic feeding machine, providing a way of analyzing samples over a long period of time without human intervention, increasing productivity and decreasing labor cost. The safety of the operator is also improved as the samples are put into the auto-sampler instead of directly between the dies and the safety shield of the dies’ chamber can be closed at all time.

Description

• Auto sample feeding structure- Computer controlled Auto sample feeding structure enables the user to put 30 pieces (or more pieces depending on request) of samples. According to settings of compound information and sequence, the sample can be automatically send into the die cavity for testing and take it out automatically from die cavity after finishing test. It can reduce the work of user would be controlled efficiently, and the testing time interval.

• EKT-2003S Moving Die Rheometer is work of the founder of Ektron Tek who is also the first computerized Rheometer designer in Asia.
• Designed and manufactured in accordance with ASTM D5289 & ISO 6502 standards.
• The torque sensor is directly attached to the upper die to avoid friction and mechanical resistance which influence sensors’ precision. The measured torque value is the real viscosity elastic property of compounds.
• This serials of Rotorless Rheometer adopt new designed die structure provides simple test piece loading and removing, and ensures the vulcanization properties of rubber compounds are presented perfectly due to the fact that test specimens in the die cavity are held firmly.
• The torque-measuring device installed on the upper die eliminates extra resistance forces generated from the oscillating structures and can enhance its sensitivity.
• During test, the computer can automatically measure some viscoelastic curves such as: Elastic torque curve, Viscous torque curve, Viscous-Elastic torque curve, Tancurve, Loss angle curve, Curing rate curve, Upper/lower die temperature curve. (Note: 2000SP model can get some more curves of foam pressure and pressure rate)
• Multiple control gates are available for controlling the specified data such as ML, MH, TS, and TC. And extra 18 control points are also supplied for the user to set some control gates at any time point of a cure curve.
• Standard accessory – SPC (Statistical Process Control) software of moving die rheometer is used to analyze and draw the statistical control charts including X-RM, -R, histogram, and normal distribution for some specified data.